Electrolux EHG682B Manual de usuario descargar pdf (Pagina 10)

Important safety requirements

This hob must be installed in accordance with the Gas

Safety (Installation and Use) Regulations (Current

Edition) and the IEE Wiring Regulations (Current

Edition).

Detailed recommendations are contained in the

following British Standards Codes Of Practice: B.S.

6172/ B.S. 5440, Part 2 and B.S. 6891 Current Editions.

The hob should not be installed in a bed sitting room

with a volume of less than 20 m

. If it is installed in a

room of volume less than 5 m

an air vent of effective

area of 110 cm

is required. If it is installed in a room of

volume between 5 m

and 10 m

an air vent of effective

area of 50 cm

is required, while if the volume exceeds

11 m

no air vent is required.

However, if the room has a door which opens directly

to the outside no air vent is required even if the volu-

me is between 5 m

and 11 m

If there are other fuel burning appliances in the same

room, B.S. 5440 Part 2 Current Edition, should be

consulted to determine the requisite air vent

requirements.

Location

The hob may be located in a kitchen, a kitchen/diner

or bed sitting room, but not in a bathroom, shower room

or garage.

Before making the cut out in the worktop ensure that

the edges of the hob that are to be near either a side

or rear wall have a minimum distance of 55 mm.

between the edge of the hob and the wall.

The minimum distance combustible material can be

fitted above the hob is 400 mm. If it is fitted below 400

mm. a space of 50 mm. must be allowed from the edges

of the hob.

The minimum distance combustible material can be

fitted directly above the hob is 700 mm.

A minimum distance of 100 mm. must be left between

the side edges of the hob and any adjacent cabinets

or walls.

Installation

IMPORTANT

This hob must be installed by qualified

personnel to the relevant British Standards.

Any gas installation must be carried out by a

registered CORGI installer.

The manufacturer will not accept liability, should

the above instructions or any of the other safety

instructions incorporated in this book be ignored.

WHEN THE HOB IS FIRST INSTALLED

Once the hob has been installed, it is important

to remove any protective materials, which were

put on in the factory.

On the end of the shaft, which includes the GJ 1/2"

threaded elbow, adjustment is fixed so that the washer

is fitted between the components as shown in the

diagram. Screw the parts together without using

excessive force.

700 mm

400 mm

100 mm

400 mm

50 mm

55 mm

50 mm

FO 0812

FITTING THE GAS HOB

WITHOUT A COOKER HOOD ABOVE

650 mm

400 mm

100 mm

50 mm

55 mm

600 mm

FO 0813

FITTING THE GAS HOB

WITH A COOKER HOOD ABOVE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

Electrolux EHG682B Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Electrolux EHG682B