Electrolux E30WD75DSS Guía de uso y cuidado descargar pdf

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS

(71.4 cm)

2" (5.1 cm)

Min.

(3.8 cm)

Min.

31"*

(78.7 cm)

3" (7.6 cm)

Max.

Spacer

** Door Open

(see note)

Electrical

Junction Box

4" X 4" (10.2 cm x

10.2 cm) opening to

route armoured

cable.

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in

the vicinity of this or any other appliance.

The first step of your installation should be to measure your current cutout dimensions and compare them

to the cutout dimensions chart below. You may find little or no cabinet work will be necessary.

NOTE:

1. Base must be capable of supporting 200 pounds (90.7 kg).

2. Make sure base is level and front of cabinet is square. If the cabinet

base is not level, the oven glides will tend to slide out

when opening the door.

Figure 1

P/N 318201519 (0411) Rev. A

English – pages 1-6

Español – páginas 7-13

Français – pages 14-20

All dimensions are in inches (cm).

Do not remove spacers on the side walls and/or on the back of the built-in oven. These spacers

center the oven in the space provided. The oven must be centered to prevent excess heat buildup that may result

in heat damage or fire.

PRODUCT DIMENSIONS

CUTOUT DIMENSIONS AND CABINET WIDTH

MODEL

30" (76.2 cm) Wall Oven

MODEL

30" (76.2 cm) Wall Oven

30 (76.2)

Min. F Max.

28½ (72.4) 29 (73.7)

29½ (74.9)

G (Min.)

24 (61)

C (Rear wrapper)

28 (71.1)

Min. H Max.

(71.8) 28

(73.3)

(61.3)

30 (76.2) Min

** NOTE: Allow at least 23¼" (59.1 cm)

clearance for door depth when it is open.

NOTE: Dimension G is critical to the

proper installation of the built-in oven. If

the oven decorative moulding does not

butt against the cabinet, or if noise is

heard on convection models, verify

dimension G to assure it is according to

the required dimension.

* Suggested distance from floor is 31" (78.7 cm).

Minimum required distance is 4½" (11.4 cm).

NOTE: For combination of this Built-in Oven with Warm &

Serve Drawer model no E30WD75DSS see cutout dimensions

specified in the Warm & Serve Drawer Installation Instructions.

Printed in the USA

1 2 3 4 5 6 7 8

Indice de contenidos

Pagina 1 - Figure 1

1ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONSABDI283/32"(71.4 cm)CHFG2" (5.1 cm)Min.11/2"(3.8 cm)Min.31"*(78.7 cm)3" (7.6 cm)

Pagina 2 - INSTRUCTIONS

2ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONSImportant Notes to the Installer1. Read all instructions contained in these installationinstructions befo

Pagina 3 - 3. Electrical connection

3ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS3. Electrical connectionIt is the responsibility and obligation of the consumer tocontact a qualified ins

Pagina 4 - 4. Cabinet Installation

4ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS4. Cabinet Installation3.Insert the unit into the cabinet opening. Slide unit inwardleaving 1 1/2" (

Pagina 5

5ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONSGFH36” Min.(91.4 cm) Min.Use 3/4” (1.9 cm) plywood, installedon two runners, flush with toe plate.Must be

Pagina 6 - 5. Checking Operation

6ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS5. Checking OperationIf your model is equipped with an Electronic OvenControl. Each of the functions has

Pagina 7 - Side View

For all approved gas cooktop models, a minimumheight opening of 6-1/2" (from top of counter) requiredin right cabinet side panel and/or filler pa

Pagina 8

For all approved electric cooktop models, cut minimum4" x 4" opening in right cabinet side panel and/or fillerpanel, to route armoured cable