Electrolux ELM5200 Manual de usuario Pagina 11

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 15
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 10
11
EN
KR
Troubleshooting/문제 해결
Problems Causes Solutions
The machine does not turn on. The machine is not connected to the
power source.
Connect the machine to the power source.
Contact Electrolux customer service.
The pump is very noisy. Both indicator
lights for small and big cups are ash-
ing. No water ow.
No water in the tank. Fill the tank with fresh drinking water.
1. Prime the water circuit.
2. Check correct water tank position.
The loading lever doesn’t reach the
brewing position.
Capsule inserted incorrectly. Empty the used capsule compartment.
Repeat the sequence, open and close the lever. If
that is not enough remove the capsule manu-
ally from the compartment after unplugging the
machine.
The coee is cold. Preheat the cup with the hot water.
The coee is brewed too fast, the
brewed coee is not creamy.
Capsule already used. Open the lever and insert a new capsule.
Coee is not brewed or brewed in
drips only.
Coee spout is clogged Clean the coee spout.
Circuit is not primed Prime the water circuit.
Hot water/steam is not dispensed. Hot water/steam spout is clogged. Clean the steam spout with a needle (the machine
needs to be unplugged and the steam/hot water
knob needs to be closed).
The milk does not froth. Not suitable milk. Use fresh, partially skimmed milk.
The milk is too hot. Use milk at refrigerator temperature.
The hot water/steam spout is clogged. Clean the steam spout with a needle (the machine
needs to be unplugged and the steam/hot water
knob needs to be closed).
The machine requires a lot of time to
heat up.
The machine has limescale build up. Descale the machine.
문제점 원인
해결 방법
제품의 전원이 켜지지 않습니다. 플러그가 전원에 연결되어 있지 않습
니다.
기기의 전원을 연결시키십시오.
Electrolux 고객 서비스 센터에 연락하십시오.
펌프가 매우 시끄럽습니다. 작은 컵과
지시등이 모두 깜빡입니다.
나오지 않습니다.
탱크에 물이 없습니다. 탱크에 신선한 식수를 채우십시오.
1. 회로를 준비하십시오.
2. 정확한 물통 위치를 확인하십시오.
로딩 레버가 커피 제조 위치에 닿지
않습니다.
캡슐이 부정확하게 삽입되었습니다. 캡슐 수거 칸을 비우십시오.
과정을 반복하고 레버를 열고 닫으십시오. 충분하
않은 경우, 기기의 전원을 끄고 캡슐을 칸에서
동으로 꺼냅니다.
커피가 차갑습니다. 뜨거운 물로 컵을 미리 데우십시오.
커피가 너무 빨리 나와 크림이 진하
않습니다.
캡슐이 이미 사용됐습니다. 레버를 열고 새로운 캡슐을 넣으십시오.
커피가 우러나오지 않거나 방울
나옵니다.
커피 분출구가 막혔습니다. 커피 분출구를 세척하십시오.
회로가 준비되지 않았습니다. 회로를 준비하십시오.
뜨거운 /스팀이 분사되지 않습
니다.
뜨거운 /스팀 분출구가 막혔습니다. 바늘을 사용하여 스팀 분출구를 세척하십시오(
계의 전원을 꺼야 경우 스팀/뜨거운 스위치를
반드시 잠그십시오).
우유 거품이 생기지 않습니다. 적절한 우유가 아닙니다. 신선한 부분 탈지유를 사용하십시오.
우유가 너무 뜨겁습니다. 냉장 우유 또는 냉장 온도와 유사한 온도의 우유를
사용하십시오.
뜨거운 /스팀 분출구가 막혔습니다. 바늘을 사용하여 스팀 분출구를 세척하십시오(
계의 전원을 꺼야 경우 스팀/뜨거운 스위치를
반드시 잠그십시오).
기계 가열 시간이 오래 걸립니다. 기계에 석회가 생겼습니다. 석회를 제거하십시오.
Vista de pagina 10
1 2 ... 6 7 8 9 10 11 12 13 14 15

Comentarios a estos manuales

Sin comentarios