Electrolux EN3488MOX Manual de usuario descargar pdf (Pagina 11)

Problem Possible cause Solution

Food products prevent

that water flows into the

water collector.

Make sure that food products

do not touch the rear plate.

Water flows on the floor. The melting water outlet is

not connected to the

evaporative tray above the

compressor.

Attach the melting water out-

let to the evaporative tray.

Temperature cannot be

set.

The FastFreeze or Shop-

pingMode function is

switched on.

Switch off FastFreeze or

ShoppingMode manually, or

wait until the function resets

automatically to set the tem-

perature. Refer to "Fast-

Freeze or ShoppingMode

function".

DEMO appears on the dis-

play.

The appliance is in demon-

stration mode.

Keep the Mode pressed for

approximately 10 seconds

until a long sound is heard

and display shuts off for a

short time.

The temperature in the ap-

pliance is too low/too high.

The temperature regulator

is not set correctly.

Set a higher/lower tempera-

ture.

The food products' tem-

perature is too high.

Let the food products tem-

perature decrease to room

temperature before storage.

Many food products are

stored at the same time.

Store less food products at

the same time.

The FastFreeze function is

switched on.

Refer to "FastFreeze func-

tion".

The ShoppingMode func-

tion is switched on.

Refer to "ShoppingMode

function".

If the advice does not lead to

the desired result, contact the

nearest Authorised Service

Centre.

6.2 Replacing the lamp

The appliance is equipped with a longlife

LED interior light.

Only service is allowed to replace the

lighting device. Contact your Authorised

Service Centre.

7. INSTALLATION

WARNING!

Refer to Safety chapters.

ENGLISH

11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comentarios a estos manuales

Sin comentarios