Electrolux GK38TSIO Manual de usuario descargar pdf (Pagina 12)

WHAT TO DO IF…

Problem Possible cause and remedy

You cannot activate the appli-

ance or operate it.

• You touched 2 or more sensor fields at the same time. Only

touch one sensor field.

• There is water or fat stains on the control panel. Clean the con-

trol panel

• Activate the appliance again and set the heat setting in 7 sec-

onds.

• The child safety device or the lock or Stop+Go operates. See

the chapter Operating the appliance.

A sound operates when the ap-

pliance is deactivated.

You put something on one or more sensor fields. Remove the ob-

ject from the sensor fields.

The residual heat indicator

does not come on.

The cooking zone is not hot because it operated only for a short

time. If the cooking zone must be hot, speak to the service cen-

tre.

The heat setting changes be-

tween two heat settings.

The Power management is activated. See the section Power

management.

A sound operates and appli-

ance activates and deactivates

again. After 5 seconds one

more sound operates.

You put something . Remove the object from the sensor field.

comes on

• The Automatic Switch Off operates. Deactivate the appliance

and activate it again.

comes on

• No cookware on the cooking zone. Put cookware on the cook-

ing zone.

• Not correct cookware. Use the correct cookware.

• The diameter of the bottom of the cookware is too small for the

cooking zone. Move cookware to a smaller cooking zone.

and number come on.

There is an error in the appliance.

Disconnect the appliance from the electrical supply for some

time. Disconnect the fuse from the electrical system of the house.

Connect again. If

comes on again, speak to the service cen-

tre.

comes on

There is an error in the appliance, because a cookware boils dry.

The protection against become too hot for the cooking zone op-

erates. The Automatic Switch Off operates.

Deactivate the appliance. Remove the hot cookware. After, ap-

proximately 30 seconds activate the cooking zone again.

should go out of the display, residual heat indicator can stay. Let

the cookware become sufficiently cool and check it with the sec-

tion Cookware for the induction cooking zone.

There is no signal when you

touch the panel sensor fields.

The signals are deactivated.

Activate the signals (see OffSound Control ).

If you tried the above solutions and cannot

repair the problem, speak to your dealer or

the Customer Care Department. Give the

data from the rating plate, three-digit-letter

code for the glass ceramic (it is in the cor-

ner of the cooking surface) and an error

message that comes on.

If you operated the appliance incorrectly,

the servicing by a customer service techni-

cian or dealer will not be free of charge,

even during the warranty period. The in-

structions about the customer service and

conditions of guarantee are in the guaran-

tee booklet.

12 electrolux

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

Electrolux GK38TSIO Manual de usuario Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Electrolux GK38TSIO