Electrolux WRG980CGS Manual de usuario descargar pdf (Pagina 3)

4 5

INSTALLATIONSAFETY

SAFETY

This manual explains the proper use of your new canopy

rangehood. Please read this manual carefully before

using the product. This manual should be kept in a safe

place for handy reference.

This canopy rangehood is a domestic appliance which has

been manufactured and tested to comply with Australian

and New Zealand Standard AS/NZS 60335.2.31.

Meanings of symbols used in this manual are shown below:

THIS SYMBOL INDICATES THE POSSIBILITY

OF INJURY OR DAMAGE TO PROPERTY

THIS SYMBOL INDICATES NEVER TO DO THIS

THIS SYMBOL INDICATES ALWAYS DO THIS

READ THE FOLLOWING CAREFULLY TO AVOID

AN ELECTRIC SHOCK OR FIRE.

Young children should be supervised to ensure they

do not play with the canopy rangehood.

This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision

or instruction concerning the use of the appliance

by a person responsible for their safety.

Ensure the canopy rangehood is switched off before

carrying out maintenance, to avoid any possibility of

electric shock.

Never carry out ﬂambé cooking under the

canopy rangehood.

This canopy rangehood is not recommended

for barbeques.

This canopy rangehood cannot be installed for

external use.

Grease ﬁlters must be removed at least every four

weeks for cleaning to reduce the risk of ﬁre.

The exhaust from the canopy rangehood must not be

discharged into any heating ﬂue, which may carry

combustion products from other sources. (Fig. 1)

Exhaust air must not be discharged into a wall cavity,

unless the cavity is designed for the purpose.

There must be adequate ventilation of the room when

the canopy rangehood is used at the same time as

appliances burning gas or other fuels.

Always cover lit gas burners with pots or pans when

canopy rangehood is in use.

Always switch off gas burners before you remove pots

or pans.

Do not leave lit gas burners exposed due to the risk

of ﬁre. (Fig. 2)

ELECTRICAL CONNECTION

• Checkthatthemainsvoltagematcheswiththevoltage

on the data plate inside the canopy rangehood.

• Checkthattheinstallationcomplieswithstandards

of local gas and electricity authorities.

• Ifthesupplycordisdamaged,itmustbereplaced

by the manufacturer, its service agent or similarly

qualiﬁed person in order to avoid a hazard.

CANOPY DIMENSIONS

NOTE: The fan housing exhaust outlet is 163mm in diameter.

Use duct transition or ﬂexible pipe supplied with the canopy

rangehood as a reducer if using 150mm optional ducting

accessories. (See page 9 for optional ducting accessories).

RANGEHOOD INSTALLATIONELECTRICAL CONNECTION

Check that the installation complies with standards

of local building, gas and electrical authorities.

Before connecting to the mains supply ensure that the

mains voltage corresponds to the voltage on the rating

plate inside the cooker hood.

SAFETY WARNINGS – FOR THE INSTALLER

When installing the cooker hood, make sure you adhere

to the minimum and maximum distances from the cooker

hood base to the hob surface (as per table on right hand

side) and as required by Australian Standards.

EXHAUST DUCT INSTALLATION

The following rules must be strictly followed to obtain

optimal air extraction.

• Keepexhaustductshortandstraight

• Donotreducethesizeorrestrictexhaustduct.

• Keepbendsintheexhaustducttoaminimum.

• Whenusingexibleductalwaysinstallductwith

helix pulled taut to minimise pressure loss.

• Failuretoobservethesebasicinstructionswill

drastically reduce the performance and increase

the noise levels of the cooker hood.

Exhaust air must not be discharged into a wall cavity,

unless the cavity is designed for that purpose.

The exhaust from the cooker hood must not be

discharged into any heating ﬂue, which may carry

combustion products from other sources

NOTE: Some installations may require the telescopic exhaust

cover to be cut to length. Cut with sharp tin snips or a

ﬁne-tooth hack saw blade, taking care not to distort or dent

the exhaust cover.

FIG. 1 FIG. 2

WRG980CGS

WRG970CS

WRG980CGS

WRG970CS

WMAN_CAN_RH_Jun11.indd 5 24/06/11 2:48 PM

1 2 3 4 5 6 7

Comentarios a estos manuales

Sin comentarios

Electrolux WRG980CGS Manual de usuario Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Electrolux WRG980CGS