Electrolux EGL6382NOX Manual de usuario descargar pdf (Pagina 8)

WARNING!

Be very careful when you use

open fire in the kitchen

environment. The

manufacturer declines any

responsibility in case of the

flame misuse.

1. Push the control knob down and turn

it counterclockwise to the maximum

gas supply position ( ).

2. Keep the control knob pushed for

equal or less than 10 seconds. This

lets the thermocouple warm up. If not,

the gas supply is interrupted.

3. Adjust the flame after it is regular.

If after some tries the burner

does not light, check if the

crown and its cap are in

correct positions.

WARNING!

Do not keep the control knob

pushed for more than 15

seconds. If the burner does

not light after 15 seconds,

release the control knob, turn

it into off position and try to

light the burner again after

minimum 1 minute.

CAUTION!

In the absence of electricity

you can ignite the burner

without electrical device; in

this case approach the

burner with a flame, turn the

control knob counter-

clockwise to maximum gas

supply position and push it

down. Keep the control knob

pushed for equal or less than

10 seconds to let the

thermocouple warm up.

If the burner accidentally

goes out, turn the control

knob to the off position and

try to light the burner again

after minimum 1 minute.

The spark generator can start

automatically when you

switch on the mains, after

installation or a power cut. It

is normal.

4.3 Turning the burner off

To put the flame out, turn the knob to the

off position .

WARNING!

Always turn the flame down

or switch it off before you

remove the pans from the

burner.

4.4 Before first use

Put a cookware containing water on each

electric cooking zone, set the maximum

position and operate the hob for 10 min.

This is to burn off the residue in the

appliance. After that, operate the hob at

minimum position for 20 min. During this

period, an odour and smoke can occur.

This is normal. Make sure that the airflow

is sufficient.

4.5 Heat setting for the electric

cooking zone

Symbols Function

Off position

1 - 6

Heat settings

Use the residual heat to

decrease energy

consumption. Deactivate the

cooking zone approximately

5 - 10 minutes before the

cooking process is

completed.

Turn the knob to a necessary heat setting.

To complete the cooking process, turn the

knob to the off position.

4.6 Using the rapid hot plate

A red dot in the middle of the plate shows

a rapid hot plate. A rapid hot plate heats

up faster than usual plates. The red dots

www.electrolux.com8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comentarios a estos manuales

Sin comentarios