Electrolux EHG30200K Manual de usuario descargar pdf (Pagina 6)

Electrical connection

• Any electrical work required to install this

hob should be carried out by a qualified

electrician or competent person, in ac-

cordance with the current regulations.

• THIS HOB MUST BE EARTHED.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is an access to the

mains plug after installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains

plug.

• The appliance must not be connected

with an extension cable, an adapter or a

multiple connection (risk of fire). Check

that the ground connection is in conform-

ity with the standard and regulations

force.

• The power cable must be placed in such

a way that it does not touch any hot part.

• Connect the appliance to the mains with

a device that lets to disconnect the appli-

ance from the mains at all poles with a

contact opening width of minimum 3

mm, eg. automatic line protecting cut-

out, earth leakage trips or fuse.

• None of a parts of the connection cable

can not get a temperature 90°C.

Electrical Requirements

Any permanent electrical installation must

comply with the latest I.E.E. Regulations

and local Electricity Board regulations. For

your own safety this should be undertaken

by a qualified electrician, e.g. your local

Electricity Board, or a contractor who is on

the roll of the National Inspection Council

for Electrical Installation Contracting (NICE-

IC).

The manufacturer declines any liability

should these safety measures not be

observed.

This hob is designed to be connected to a

230 V 50 Hz AC electrical supply.

Before switching on, make sure the elec-

tricity supply voltage is the same as that in-

dicated on the hob rating plate. The rating

plate is located on the bottom of the hob.

The hob is supplied with a 3 core flexible

supply cord.

Upon completion there must be no cut, or

stray strands of wire present and the cord

clamp must be secure over the outer

sheath.

Important! A cut off plug inserted into a 13

amp socket is a serious safety (shock)

hazard. Ensure that the cut off plug is

disposed of safely.

Important! The replacement of electric

cable must be carried out exclusively by the

service force centre or by personnel with

similar competencies, in accordance with

the current regulations.

Replacement of the connection cable

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make

sure that the cable section is applicable to

the voltage and the working temperature.

The yellow/green earth wire must be ap-

proximately 2 cm longer than the brown (or

black) phase wire.

Assembly

40-50 mm

55 mm

30 mm

min. 650 mm

490 mm

min. 100 mm

600 mm

270 mm

If several 30 cm hobs are to be installed

side by side into the same cut out, an as-

sembly kit including a support side bracket

and supplementary seals is available at our

Service Centres. The relevant installation in-

structions are supplied within the kit pack-

age.

6 electrolux

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comentarios a estos manuales

Sin comentarios