Electrolux EHG30810X Manual de usuario descargar pdf (Pagina 8)

CONTROL KNOBS

Symbol Description

no gas supply / off

position

Symbol Description

ignition position /

maximum gas supply

minimum gas supply

OPERATION

IGNITION OF THE BURNER

Warning! Be very careful when you

use open fire in kitchen environment.

Manufacturer decline any responsibility

in case misuse of the flame

Always light the burner before you put

cookware.

To light the burner:

1. Turn the control knob counterclockwise

to the maximum position (

) and

push it down.

2. Keep the control knob pushed for ap-

proximately 5 seconds; this will let ther-

mocouple to warm up. If not, the gas

supply will be interrupted.

3. Adjust the flame after it is regular.

If after some tries the burner does not

light, check if the crown and its cap are

in correct positions.

1

2

3

4

1

Burner cap

2

Burner crown

3

Ignition candle

4

Thermocouple

Warning! Do not keep the control

knob pushed for more than 15

seconds.

If the burner does not light after 15

seconds, release the control knob, turn

it into off position and try to light the

burner again after minimum 1 minute.

Important! In the absence of electricity you

can ignite the burner without electrical

device; in this case approach the burner

with a flame, push the relevant knob down

and turn it counter-clockwise to maximum

gas release position.

If the burner accidentally goes out, turn

the control knob to the off position and

try to light the burner again after mini-

mum 1 minute.

The spark generator can start automat-

ically when you switch on the mains,

after installation or a power cut. It is

normal.

TURNING THE BURNER OFF

To put the flame out, turn the knob to the

symbol

.

Warning! Always turn the flame down

or switch it off before you remove the

pans of the burner.

8 electrolux

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios