Electrolux EHG90839X Manual de usuario descargar pdf (Pagina 15)

electrolux 15

Conversion from LPG to Natural Gas

A. Injectors replacement

• Ensure that the gas taps are in the

'OFF' position

• Isolate the hob from the electrical

supply

• Remove all pan supports, burner

caps, rings, crowns and control

knobs.

)

Gas Connection

Connection to the gas supply should be

with either rigid or semi-rigid pipe, i.e.

steel or copper.

The connection should be suitable for

connecting to RC 1/2 (1/2 BSP male

thread).

When the final connection has been

made, it is essential that a thorough leak

test is carried out on the hob and

installation.

Ensure that the main connection pipe

does not exert any strain on the hob.

It is important to install the elbow

correctly, with the shoulder on

the end of the thread, fitted to the

hob connecting pipe.

Failure to ensure the correct

assembly will cause leakage of

gas.

A) End of shaft with nut

B) Washer

C) Elbow

IMPORTANT

The replacement/conversion of the gas

hob should only be undertaken by a

competent person.

It is important to note that this model is

designed for use with LPG gas but can

be converted for use with Natural gas

providing the correct injectors are fitted

and the gas rate is adjusted to suit.

Replace the rating label (placed near the

gas supply pipe) with the relevant one

for the new type of gas supply. You can

find this label in the package of the

injectors supplied with the appliance.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Comentarios a estos manuales

Sin comentarios