Electrolux EHG9832X Manual de usuario descargar pdf (Pagina 8)

8 electrolux

Hob burners control knobsHob burners control knobs

Hob burners control knobs

The symbols on the knobs mean that :

 there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burnersLighting the burners

Lighting the burners

For easier lighting, proceed beforeFor easier lighting, proceed before

For easier lighting, proceed before

putting a pan on the pan support.putting a pan on the pan support.

putting a pan on the pan support.

To light a burner:

 push in the relevant control knob and turn

it anticlockwise to maximum position (

to ignite the burner.

 Upon ignition, keep the knob pushed

down about

5 seconds. This will allow

the "thermocouple" (Fig. 1 - letter D) to be

heated and the safety device to be

switched off, otherwise the gas supply

would be interrupted.

 Then adjust the flame as required.

If the burner does not ignite, turn the

control knob to zero, and try again.

When switching on the mains, after

installation or a power cut, it is quite

normal for the spark generator to be

activated automatically.

In the absence of electricity, ignition can

occur without the electrical device; in this

case, approach the burner with a flame,

push the relevant knob down and turn it anti-clockwise until it reaches

the “maximum” position.

If the control knobs become difficult to turn, please contact your

local Service Force Centre.

OperationOperation

Operation



Fig. 1

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple

Triple Crown Burner

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Comentarios a estos manuales

Sin comentarios

Electrolux EHG9832X Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Electrolux EHG9832X