
1. The bench cutout should be made as per ‘BENCH
CUTOUT SIZE’ table (Figure 5).
2. Adjacent walls, cupboards and protection for
combustible materials: Ensure that the appliance
is installed with Section 5.12.1 of AS 5601 (AG 601)
(Australia) or Section 14.1 of NZS 5261 (New Zealand),
regarding clearances to combustible surfaces and
materials, and clearance to rangehoods and
exhaust fans.
To ensure clearances of 200mm from burners to
vertical combustible surfaces observe the dimension
shown in Figure 6.
Clearances to combustible materials may be reduced
if combustible surfaces are protected in accordance
with clause 5.12.1.2 of AS 5601 (AG 601) (Australia) or
section 14.1.2 of NZS 5261 (New Zealand).
3. Safety barrier: A barrier can be installed to prevent
accidental contact with the cooktop base, where the
base of the cooktop is
accessible from below (ie inside a cupboard, etc).
Impressions have been incorporated into the base to
ensure a minimum clearance of 10mm is maintained
between the base and the barrier. This barrier may be
made of any rigid material.
4. Pull down clamps are supplied in a parts bag consisting
of 4 clamps and 4 screws. To assemble attach the
4 clamps to each corner of the burner box via the
screws provided. When placing he appliance in the
cutout, swing the clamps parallel with the box to avoid
interference with the cutout. When the appliance is in
position swing the clamps under the bench top and
tighten (see Figure 7).
5. A FOAM SEAL has been provided and is to be applied
along the perimeter of the glass (see Figure 8).
Installation procedure
140mm
Combustible surface
110mm
Figure 6
Figure 7
S/S Trim
Ceramic Hob
Burner Box
Screw
Clamp
Benchtop
Bottom cover
Foam tape
Glass
Bottom view
8 electrolux e:line gas cooktops installation
Figure 8
Comentarios a estos manuales