Electrolux EHI745BA Manual de usuario Pagina 8

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 20
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 7
8 electrolux.com.au
OPERATING INSTRUCTIONS
Automatic heat up
You can get a necessary heat setting in a shorter time
if you activate the Automatic Heat Up function. This
function sets the highest heat setting for some time (see
the graphic), and then decreases to the necessary heat
setting. To start the Automatic Heat Up function for a
cooking zone:
1. Touch ( comes on in the display).
2. Immediately touch the necessary heat setting. After
3 seconds comes on in the display. To stop the
function change the heat setting.
Switching on and off the power function
The Power function makes more power available to the
induction cooking zones. The Power function is activated
for 5 minutes at most. After that the induction cooking
zone automatically switches back to heat setting . To
switch on, touch , comes on. To switch off, touch a
heat setting between and .
Power management
The power management divides the power between two
cooking zones in a pair (see the illustration). The power
function increases the power to the maximum level for one
cooking zone in the pair. The power in the second cooking
zone automatically decreases. The heat setting display for
the reduced zone changes between two levels.
Timer
You can set one timer function for each cooking zone
separately. To set a timer function for the zones on the left
side use the timer on the left, for the zones on the right, the
timer on the right.
Count Down Timer
Use this function to specify how long a cooking zone
should operate during a single cooking session.
First set the heat setting for the cooking zone and then
set the function.
To activate the function or change the quickly again
and again until the indicator of a given zone lights up on
the display. Then touch or to set the time
(00 - 99 minutes). The function starts automatically after 4
seconds
comes on the display.
To activate the timer function for the second zone in a pair
touch 3 times quickly.
When the time comes to an end, a signal sounds and 00
flashes. Touch to stop the signal.
To see the remaining time: touch .
To deactivate the function: choose the desired zone
touching and then touch. The remaining time counts
back to 00.
The symbol goes out.
CountUp Timer (The count up timer). You can use this
function to monitor how long a cooking zone operates.
To activate the function: for the first zone in a pair touch
twice quickly. The function starts automatically when
lights up. To activate the function for the second zone in a
pair touch 4 times quickly.
To see how long the cooking zone operates: touch . The
display shows the time, at first in seconds then in minutes.
To deactivate the function: choose the desired zone
touching and then touch. The symbol goes out.
Minute Minder
You can use this function as a Minute Minder when the
hob is activated but the cooking zones do not operate.
To activate the function: touch quickly again and again
until the indicator of a given zone lights up on the
display. Touch or to set the time. The function starts
automatically after 4 seconds comes on the display.
When the time comes to an end, a signal sounds and 00
flashes. Touch to stop the signal.
IMPORTANT!
The function has no effect on the operation of the
cooking zones.
Vista de pagina 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comentarios a estos manuales

Sin comentarios