Electrolux EHL2CN Manual de usuario descargar pdf (Pagina 25)

45°

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side down

on a soft cloth on a stable surface.

This is to prevent scratches.

When the cleaning is completed, install the

door. Do the above steps in the opposite

sequence.

9.5 Replacing the lamp

Put a cloth on the bottom of the interior of

the appliance. It prevents damage to the

lamp glass cover and the cavity.

WARNING!

Danger of electrocution!

Disconnect the fuse before

you replace the lamp.

The lamp and the lamp glass

cover can be hot.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box

or deactivate the circuit breaker.

The top lamp

1. Turn the lamp glass cover

counterclockwise to remove it.

2. Clean the glass cover.

3. Replace the lamp with a halogen, 230

V, 40 W, 300 °C heat resistant lamp.

4. Install the glass cover.

10. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

10.1 What to do if...

Problem Possible cause Remedy

The cooking zones do not

operate.

Refer to the operating instructions for the built-in cooking

surface.

The oven does not heat up. The oven is deactivated. Activate the oven.

The oven does not heat up. The fuse is released. Make sure that the fuse is

the cause of the malfunc-

tion. If the fuse releases

again and again, contact a

qualified electrician.

The lamp does not operate. The lamp is defective. Replace the lamp.

Steam and condensation

settle on the food and in the

cavity of the oven.

You left the dish in the oven

for too long.

Do not leave the dishes in

the oven for longer than 15

- 20 minutes after the cook-

ing process ends.

ENGLISH

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Comentarios a estos manuales

Sin comentarios

Electrolux EHL2CN Manual de usuario Pagina 25

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Electrolux EHL2CN