Electrolux EHL2S7000W Manual de usuario descargar pdf (Pagina 26)

When installing next to a wood-fuelled

boiler, a heatproof and heat-insulating

plate must be mounted at the height of

the appliance and at least 30 cm deep.

A B

A

min. 20 mm

10

mm

20 mm

Electrical connection

WARNING! If service is

required always disconnect the

appliance from the power

supply.

Use a power cable of H05VV-F or higher.

Install the appliance with a socket supply

line. If there is no socket supply line, the

fixed home electrical system must include

an isolating device with at least a 3 mm-

contact separation to enable a

simultaneous and all-pole cut off from the

mains (according to NIN SEV 1000). The

customer must have a socket for the

electrical connection that is accessible

and outside the coordination room. The

length of the connection cable must be

approximately 120 cm with lines

connected directly to the mains.

Only a qualified person can

connect the appliance to the

electricity supply.

1. Open the mains terminal cover (D).

D

E

F

2. Put the connection cable into the

supplied rings (E).

This is to prevent the cable from

rubbing against the drawer. The

connection cable is on the housing

side.

3. Install the cable grip (F).

4. Connect the terminal as in the

illustration.

5. Put the cable into the strain relief

clamp.

6. Close the mains terminal cover.

7. Do the electrical connections as in the

connection illustration.

Phase definitions: L1, L2, L3 (or R, S,

T).

Voltage: 400V

8. Secure the cable grip.

ENERGY EFFICIENCY

Product Fiche and information according to EU 65-66/2014

Supplier's name Electrolux

Model identification EHL2S7000W

Energy Efficiency Index 103.5

26

1 2 ... 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios