Electrolux EHL8740FOG Manual de usuario descargar pdf (Pagina 14)

Problem Possible Remedy

comes on.

There is an error in the ap-

pliance because a cook-

ware boils dry. The over-

heating protection for the

cooking zones and the

Automatic Switch Off op-

erate.

Deactivate the appliance.

Remove the hot cook-

ware. After approximately

30 seconds, activate the

cooking zone again. If the

cookware was the prob-

lem, the error message

goes out of the display,

but the residual heat indi-

cator can stay. Let the

cookware become suffi-

ciently cool and refer to

“Cookware for the induc-

tion cooking zone” to see

if your cookware is com-

patible with the appliance.

comes on.

The cooling fan is blocked. Check if objects block the

cooling fan. If

comes

on again, speak to the

service center.

comes on.

The electrical connection

is incorrect. The appliance

is connected only to one

phase.

Connect the appliance as

you see it in the connec-

tion illustration.

If you tried the above solutions and cannot

repair the problem, speak to your dealer or

the customer service. Give the data from

the rating plate, three digit letter code for

the glass ceramic (it is in the corner of the

glass surface) and an error message that

comes on.

Make sure, you operated the appliance

correctly. If not the servicing by a customer

service technician or dealer will not be free

of charge, also during the warranty period.

The instructions about the customer serv-

ice and conditions of guarantee are in the

guarantee booklet.

7. INSTALLATION

WARNING!

Refer to "Safety information" chap-

ter.

Before the installation

Before the installation of the appliance, re-

cord the information below from the rating

plate. The rating plate is on the bottom of

the appliance casing.

• Model ...........................

• PNC .............................

• Serial number ....................

7.1 Built-in appliances

• Only use the built-in appliances after you

assemble the appliance into correct

built-in units and work surfaces that align

to the standards.

7.2 Connection cable

• Use the correct mains cable of type

H05BB-F Tmax 90°C (or higher) for a

single phase or two phase connection.

• Replace the damaged mains cable with

a special cable (type H05BB-F Tmax

90°C or higher). Speak to your local

Service Centre.

14

www.electrolux.com

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios