Electrolux EHP601X Manual de usuario descargar pdf (Pagina 13)

Hob installation

D Cut out the worktop acc. to prescribed cutout size.

The tolerance sizes must not be exceeded. Do

precisely saw at the mark line. Recommendation:

Mark the cutout with a steel needle. Glue some-

thing on the line in order to avoid shattering of the

coat when cutting.

D With tile--coated worktop areas the slits in the

supporting area for the cooking area must be filled

up completely.

D Clean the worktop in the cutout area

D The cooking area is entered from the top into the

cut--out section, centered and firmly pressed on

until the springs will catch.

D Check the sealing in the supporting frame for per-

fect seating and resting without a gap. Please do

not apply additional silicone sealing material, the

closure will make it harder to dismantle in case of

need for service.

D 4 holes in the bottom of the build--in case are pro-

vided for the screws of the fitting plates.

D At first screw on the fitting plates by a screwdriver

and afterwards regularly tighten the plates alter-

natively and diagonally offset

, until the frame of

the cooking area is perfectly laying on the work-

top.

D Over--tightening must be avoided! Electric screw-

drivers or pusher airscrews to be exclusively used

with slip clutch (setting value 1 -- 1.1 Nm).

frame

ceramic glass plate

fixing clamp

worktop

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Electrolux EHP601X Manual de usuario Pagina 13