Electrolux EHS6140HOW Manual de usuario descargar pdf (Pagina 10)

Supply connections:

This hob has to be connected to 230 —

240 V ( 50 Hz) electricity supply.

The hob has a terminal block which is

marked as follows:

• L — Live terminal

• N — Neutral terminal

•

or E — Earth terminal

Before carrying out the connection, make

sure:

1.

The limiter valve and the electrical

system can take the appliance load

(see the rating plate)

2.

The supply system is equipped with

an efficient earth connection in com-

pliance with the current standards

and regulations

3.

The outlet or omnipolar switch used

for connection is easily accessible

with the appliance installed.

You must purchase and install the plug (if

applicable). Use only a connection cable

of type H05V2V2-F T90 or its equivalent.

Make sure that the cable section is appli-

cable to the voltage and the working tem-

perature.

In any case the power cable must be

positioned in such a way that no part of it

reaches a temperature of 50° C higher

than the ambient temperature.

The wires in the cord are coloured as fol-

lows:

Green and yellow - Earth

Blue - Neutral

Brown - Live

1.

Remove the mains terminal cover

plate from the bottom side of the hob

to uncover the mains terminal block.

2.

Loosen the two cable clamp screws

and lift the top side of the clamp so

the cable can go through it.

3.

Connect the green and yellow (earth)

wire to the terminal in the plug which

is marked with the number 5 or the

letter 'E', or the earth symbol

, or

coloured green and yellow. (see Fig-

ure 1)

4.

Connect the blue (neutral) wire to the

terminal in the plug which is marked

with the number 4 or the letter 'N' or

coloured blue. (see Figure 1)

5.

Connect the brown (live) wire to the

terminal in the plug which is marked

with the number 1, the letter 'L'. It

must always be connected to the net-

work phase. (see Figure 1)

Figure 1

12345

There must be no cut or stray strands of

wire present. The cord clamp must be

correctly attached to the outer sheath.

Connection Min. size

cable /

flex

Fuse

Appliance con-

trol circuit

6 mm² 30 A

The yellow / green earth wire (B)

must be approximately 2 cm lon-

ger than the phase and neutral

wire (A).

AB

WARNING!

Make sure to get rid of the cut off

plug safely. A cut off plug put into

a 13 amp socket is a safety risk.

There is a risk of electrical shock.

According to the current regula-

tions only a qualified electrician or

competent person can replace the

mains cable.

10

www.electrolux.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios