
26 electrolux
Models in stainless steel or aluminium:
We recommend to clean the oven
door using only a wet sponge and dry it
up after cleaning with a soft cloth.
Never use steel wool, acids or
abrasive products as they can damage
the oven surface.
Clean the oven control panel following
the same precautions.
The correct operation of the oven is
ensured by a gasket placed round the
edge of the oven cavity.
• Periodically check the condition of
this gasket. If necessary, clean it with-
out using abrasive cleaning products.
• If the gasket shows to be damaged,
call you local Service Centre. Do not
use the oven until it has been repaired.
Lid cleaning
The crystal lid can be dissasembled
to allow a better cleaning ( see Fig. 12).
Clean the crystal lid only with warm
water and avoid the use of rough cloths
or abrasive substances.
After a proper cleaning, carefully
reposition the lid into its hinges.
Balancing the lid
Appliances provided with crystal lids
are equipped with specially balanced
springs, inserted in the hinges at the
back of the appliance, to allow the lid to
be closed smoothly and easily.
You can use a screwdriver to adjust
the closure of the lid. The necessary
force for opening/closing the lid can be
increased by turning the adjusting screw
2 or 3 times as shown in figure 13.
Controls - Sundries
Periodically check the condition of
the flexible pipe of gas connection and
make it replaced by skilled technicians
as soon as it shows abnormalities. An-
nual replacement is recommended.
Fig. 12
Fig. 13
Comentarios a estos manuales