Electrolux EQTP4520IK GH2 Manual de usuario descargar pdf (Pagina 9)

4.2 Automatic Switch Off

The function deactivates the hob

automatically if:

• All roasting zones are deactivated.

• You do not set the temperature after

you activate the hob.

• You spill something or put something

on the control panel for more than 10

seconds, (a pan, a cloth, etc.). An

acoustic signal sounds and the hob

deactivates. Remove the object or

clean the control panel.

• You do not deactivate a roasting zone

or change the temperature. After 90

minutes comes on and the hob

deactivates. Before next use, set the

roasting zone to .

4.3 The heat setting

To set or change the heat setting:

Touch the control bar at the correct heat

setting or move your finger along the

control bar until you reach the correct heat

setting.

The display flashes until the roasting zone

reaches the temperature. Then a signal

sounds and the display shows the

temperature.

4.4 Timer

Count Down Timer

You can use this function to set how long

the roasting zone should operate for a

single cooking session.

First set the roasting zone then set

the function. The selection of the Timer

function is possible for roasting zones that

are active and after the temperature is set.

To set the roasting zone: touch

again and again until the indicator of a

necessary roasting zone comes on. When

this function is active, comes on.

To activate the function: touch of

the timer to set the time (00 - 99 minutes).

When the indicator of the roasting zone

starts to flash slowly the time counts

down.

To see the remaining time: set the

roasting zone with

. The indicator of

the roasting zone starts to flash quickly.

The display shows the remaining time.

To change the time: set the roasting

zone with . Touch or .

To deactivate the function: set the

roasting zone with

and touch . The

remaining time counts back to 00. The

indicator of the roasting zone goes out.

When the time comes to an

end, the sound operates and

00 flashes. The roasting zone

deactivates.

To stop the sound: touch .

CountUp Timer (The count up

timer)

You can use this function to monitor how

long the roasting zone operates.

To set the roasting zone (if more than

1 roasting zone operates): touch

again and again until the indicator of a

necessary roasting zone comes on. When

this function is active, comes on.

To activate the function: touch . The

symbol goes out and comes on.

To see how long the roasting zone

operates: set the roasting zone with .

The indicator of the roasting zone starts to

flash quickly. The display shows how long

the zone operates. During the first minute

the display shows the time in seconds.

After the first minute the display shows the

time in minutes.

ENGLISH

9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comentarios a estos manuales

Sin comentarios