Electrolux FEH50P2 Manual de usuario descargar pdf (Pagina 21)

1. Install the anti-tilt protection 317 - 322

mm down from the top surface of the

appliance and 80 - 85 mm from the

side of the appliance into the circular

hole on a bracket. Screw it into the

solid material or use applicable

reinforcement (wall).

80-85

mm

317-322

mm

2. You can find the hole on the left side

at the back of the appliance. Lift the

front of the appliance and put it in the

middle of the space between the

cupboards. If the space between the

bench cupboards is larger than the

width of the appliance, you must

adjust the side measurement to centre

the appliance.

If you changed the

dimensions of the cooker,

you must align the non-tip

device correctly.

CAUTION!

If the space between the

bench cupboards is larger

than the width of the

appliance, you must adjust

the side measurement to the

centre of the appliance.

14.5 Electrical installation

WARNING!

The manufacturer is not

responsible if you do not

follow the safety precautions

from Safety chapters.

This appliance is supplied without a main

plug or a main cable.

Applicable cable type: H05 RR-F with

adequate cross-section.

WARNING!

Before you connect the

mains cable to the terminal,

measure the voltage between

phases in the house network.

Then, refer to the connection

label at the back of the

appliance to use the correct

electrical installation. This

order of steps prevents from

installation errors and

damage to the electrical

components of the appliance.

WARNING!

The power cable must not

touch the part of the

appliance shown in the

illustration.

ENGLISH

21

1 2 ... 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios