Electrolux GHL346SW Manual de instalación Pagina 8

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 12
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 7
Picture 1
2. Carefully clean the worktop around
the cut-out and the cut-out edges.
3. The rubber seal (A) has to be glued
onto the surface where the worktop
and the hob touch to prevent
vibrations and protect the glass
against mastic.
Picture 2
A
B
4. Make sure to install the oven and the
burners according to the installation
instructions.
5. Place the glass hob carefully in the
cut-out and then level it making
allowance for the seal around the
edges. As the actual dimensions of
the glass hob and the cutout may
vary, the size of the joint also can be
different by minimum 2 mm.
6. Place the burner cap, burner crown
and the round profile onto burner
base so the ignition candles and
thermocouples extend through their
respective holes. Push the burner
head down firmly until it clicks into its
place correctly.
7. Secure the round profiles, with 2
screws each, onto the burners in the
cooking surface. In this way the hob
is secured to the worktop.
8. Put in place and adjust the burner
crowns and the burner caps. Place
the pan supports in the appropriate
indentations.
Make the final check whether the
appliance functions correctly and the gas
installation is safe.
1.15 Gas burners and diameter of the injectors
Stainless steel hob GKM45CN
Gas type Burner Injector
Mark
1/100 mm
Nomi-
nal
heat
input
kW
Reduced
heat in-
put kW
Gas consumption
m
3
/h
g/h
G30 G31
Natural
gas (2H)
20 mbar
Semi -
rapid
96 2.0 0.45 0.190 - -
Auxiliary 70 1.0 0.33 0.095 - -
Oven 2.7 0.7 0.257 - -
www.electrolux.com8
Vista de pagina 7
1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios