Electrolux EXP12EN1WI Manual de usuario

EXP12EN1WI... ...EN PORTABLE AIRCONDITIONERUSER MANUAL

appear in the display of the remote control;depress the Lock button LOCK again to re-lease. Use a small pin to depress these but-tons.OPERATING INSTRU

To cancel the timer setting simply tap or button to change the timing to 0.0.SLEEP OPERATION (SLEEP)In this mode the selected temperature willincrea

Fan only (FAN) or Heat (HEAT). This is tocover possibility of having to roll throughto select another mode.• After a power outage, the unit will memo-

WHAT TO DO IF…Problem Possible cause RemedyAir conditioner will not operate Wall plug disconnected. Push plug firmly into wall outlet. Plug current d

Problem Possible cause Remedy Doors, windows, registers, etc.open — cool air escapes.Close doors, windows, regis-ters, etc. Unit recently turned on

For other non-EU countries: Please con-tact your local authorities for correct meth-od of disposal of the used battery.Battery, including those which

www.electrolux.com/shop 2020252a0429-A-042012

Electrolux. Thinking of you.Share more of our thinking at www.electrolux.comCONTENTSSafety information 2Product description 4Accessories 4Install

— 240V, 50Hz, 10A mains electricitysupply.• The appliance must be earthed.• The appliance is equipped with a cordhaving an earth wire connected to agr

PRODUCT DESCRIPTIONUNIT DESCRIPTION4321 561234561CONTROL PANEL2CARRYING HANDLE (BOTH SIDES)3REMOTE CONTROL STORAGE DOOR4REMOTE CONTROL5ROOM AIR DISCHA

PART PART NAME QUANTITYC Window/Exhaust Adaptor B 1 pcD Window Sliding Kit 1 pcEFoam Seal 3 pcF Remote Control 1 pcG Battery (for remote control) 2 pc

4. Extend the other side of the hose andscrew it to adaptor B.5. Slide the assembly onto unit.6. Affix the adaptor B into the windowslider kit and sea

WALL DISCHARGEMount wall adaptor directly over correctlyinstalled duct to outside. (This usually in-cludes aluminium wall ducting and an out-side cove

4. Close the window sash securelyagainst the window slider kit.5. Cut the foam seals to an appropriatelength and seal the open gap betweenthe top wind

CONTROL PANELCONTROL PANEL1 2 3 4 56789101CHECK FILTER RESET BUTTON2DISPLAYS TEMPERATURE/TIME3TURNS UNIT ON OR OFF4REMOTE SIGNAL RECEIVER5SWING BUTTON