Electrolux EKC6562AOX Manual de usuario descargar pdf (Pagina 27)

B

1. Install the anti-tilt protection (A) on

the wall.

Make sure that the wall is made of a

solid material. If not, you need to

make the wall sufficiently strong to

hold the weight.

Make sure that the surface behind

the appliance is smooth.

2. Put the appliance in the middle of the

space between the cupboards.

If the space is larger than the width of

the appliance, you must adjust the

side measurement.

3. Install the anti-tilt protection (A)

approximately 77 mm below the top

surface of the appliance and 50 mm

from the left or right side of the

appliance into the circular hole on the

bracket. Screw it into the wall.

50 mm

77 mm

A

4. Check that the anti-tilt protection (A)

fits minimum 20 mm into the hole in

the rear wall of the appliance (B)

when you push the appliance.

13.5 Electrical installation

WARNING!

The manufacturer is not

responsible if you do not

follow the safety precautions

from Safety chapters.

This appliance is supplied without a main

plug or a main cable.

13.6 Covering terminal board

• The recommended cross-section area

is six square millimetres (6 mm²).

• When you refit the mains terminal

cover, make sure that the lower tabs

are located inside the bottom edge of

the aperture, before you fix the two

screws into the top edge of the mains

terminal cover.

• Make sure that the cover is securely

fastened.

To open the cover of

terminal board obey the

procedure in opposite

sequence.

13.7 Terminal board

Do not remove blanking

plates.

Make sure that the links are fitted as

shown.

N N N

LL

ENGLISH 27

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Comentarios a estos manuales

Sin comentarios