Electrolux EOU5420AOX Manual de usuario descargar pdf (Pagina 19)

CAUTION!

Always turn the oven light on

while using the catalytic

cleaning (if applicable).

Before activating the catalytic

cleaning remove all the

accessories from the oven.

The walls with a catalytic coating are self-

cleaning. They absorb fat which collects

on the walls while the appliance operates.

To support the self-cleaning procedure,

heat the empty oven on a regular basis.

1. Clean the oven floor with warm water

and washing up liquid, then dry it.

2. Set the function if applicable. If not,

set .

3. Set the temperature to 250ºC and let

oven operate for 1 hour.

4. When the appliance is cool, clean it

with a soft and moist sponge.

10.5 Removing and installing the

door

You can remove the door and the internal

glass panels to clean it. The number of

glass panels is different for different

models.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully lift up the clamping levers (A) on

the two door hinges.

A

A

3. Close the door until it is at an angle of

approximately 45°.

45°

4.

Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side down

on a soft cloth on a stable surface.

This is to prevent scratches.

6. Hold the door trim (B) on the top edge

of the door at the two sides and push

inwards to release the clip seal.

1

2

B

CAUTION!

Rough handling of the glass,

especially around the edges

of the front panel, can cause

the glass to break.

7. Pull the door trim to the front to

remove it.

8. Hold the door glass panels on their

top edge one by one and pull them up

out of the guide.

9. Clean the glass panel with water and

soap. Dry the glass panel carefully.

ENGLISH

19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios