Electrolux EBCSL70SP Manual de usuario Pagina 19

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 24
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 18
11.4 Removing / installing the
oven door
Remove the door to clean the inner side
of the appliance more easily.
3
4
2
Removing the oven door
1.
Open the door as far as possible.
2.
Fully release the clamping levers on
the hinges.
3.
Hold the door on the two sides and
close it approximately 3 / 4 of the
way, going through the point of resist-
ance.
WARNING!
Pull the door away from the oven.
The door it is heavy.
CAUTION!
Put the door with the outer side
down on a soft and level surface.
3
4
4
60º
5
Installing the oven door
1.
Hold the door on the two sides at an
angle of approximately 60°.
2.
Push the door hinges at the same
time into the two recesses at the bot-
tom of the oven on the left and the
right, as far as they go.
3.
Lift the door up until you meet the
point of resistance and then open it
as far as possible.
4.
Fully lock the clamping levers on the
hinges
5.
Close the oven door.
11.5 Lamp
WARNING!
Danger of electrocution! Discon-
nect the fuse before you replace
the lamp.
The lamp and the lamp glass cov-
er can be hot.
Before you change the lamp:
Deactivate the appliance.
Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the
interior of the appliance. It pre-
vents damage to the lamp glass
cover and the cavity.
Always use the same lamp type.
Replacing the side lamp:
1.
Remove the left shelf support.
2.
Use a Torx 20 screwdriver to remove
the cover.
3.
Remove and clean the metal frame
and the seal.
4.
Replace the lamp with a halogen, 230
V, 25 W, 300 °C heat resistant oven
lamp.
5.
Install the metal frame and the seal.
Tighten the screws.
6.
Install the left shelf support.
ENGLISH 19
Vista de pagina 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios