Electrolux ERT1372 Manual de usuario descargar pdf (Pagina 5)

Technical specifications

The technical data is indicated in the rating plate on the left side

inside the appliance.

Height 850 mm

Width 495 mm

Depth 600 mm

Installation

Take utmost care when handling your appliance so as not

to cause any damages to the cooling unit with consequent

possible fluid leakages.

¥ During normal operation, the condenser and compressor at the

back of the appliance heat up considerably. Always ensure that

there is adequate ventilation as a failure to do this will result in

component failure and possible food loss. See installation

instructions.

Important: if the supply cord is damaged, it must be replaced by

a special cord or assembly available from the manufacturer or its

service agent.

Positioning

¥ Unpack the cabinet and check that it is in good condition and

free of any transport damage.

¥ Place the refrigerator away from direct sunlight and heat

sources.

¥ Maintain recommended ventilation.

¥ For safety reasons, minimum ventilation must be as shown in the

figure.

Appliance positioned under overhanging kitchen wall units (see

Fig.-A). Appliance positioned without overhanging kitchen units

(see Fig.-B).

Attention: keep ventilation openings clear of obstruction.

¥ Two adjustable feet at the cabinet base allow accurate levelling

of the appliance.

100 mm10 mm

10 mm

NP008

The climate classification can be found on the rating plate, which

is located inside the cabinet on the left hand wall.

The following table shows which ambient temperature is correct

for each climate classification:

Climate

classification

SN +10 to +32¡C

+16 to +32¡C

+18 to +38¡C

+18 to +43¡C

for an ambient temperature of

Electrical connection

Before plugging in, ensure that the voltage and frequency shown

on the serial number plate correspond to your domestic power

supply.

Voltage can vary by ±6% of the rated voltage.

For operation with different voltages, a suitably sized auto-

transformer must be used.

Important

The appliance must be earthed.

The power supply cable plug is provided with a contact for

this purpose.

If the domestic power supply socket is not earthed.

connect the appliance to a separate earth in compliance

with current regulations, consulting a specialist technician.

The Manufacturer declines all responsibility if the

above safety precautions are not observed.

This appliance complies with the following E.E.C. Directives:

- 87/308 EEC of 2/6/87 relative to radio

interference suppression.

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent modifications.

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modifications.

Attention!

It must be possible to disconnect the appliance from the

mains power supply; the plug must therefore be easily

accessible after installation.

Door reversal

Proceed as follows:

1. remove screws (A) which secure the worktop (B) on the back;

2. move the top (B) slightly to release it from the retainers and

remove it;

3. Unscrew the top hinge (C) and reÞt it on the opposite side.

4. Refit the worktop (B).

1 2 3 4 5 6 7

Comentarios a estos manuales

Sin comentarios

Electrolux ERT1372 Manual de usuario Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para No Electrolux ERT1372