Electrolux VACS140SP Manual de usuario descargar pdf (Pagina 13)

13ENGLISH

8. TROUBLESHOOTING

CAUTION!

Refer to the chapters on safety.

8.1 What to do if…

Problem Possible cause Solution

The pouch is not

sealed correctly.

The sealing time is not correct. Change the sealing time.

The cover gasket is dirty or

worn.

Clean or replace the cover

gasket (contact the Technical

Assistance Service for a

replacement).

The pouch is not placed

correctly on the sealing bar.

Position the pouch correctly.

The sealing bar is worn (the

Teon coating is burnt).

Replace the sealing bar (contact

the Technical Assistance

Service for a replacement).

The blade placed under the

Teon of the sealing bar is

broken.

Replace the blade (contact the

Technical Assistance Service for

a replacement).

Final vacuum is

poor.

The set vacuum level is not

correct.

Change the vacuum level.

The cover gasket is dirty or

worn.

Clean or replace the cover

gasket (contact the Technical

Assistance Service for a

replacement).

The cover is not closed

correctly.

Close the cover correctly.

Make sure that objects or dirt

are not found between the cover

and tank.

The cover does

not open.

No power supply. Wait until the power supply is

restored.

The cover is

cracked or

broken.

Damaged cover. Replace the cover (contact the

Technical Assistance Service for

a replacement).

The and

buttons ash.

“Reconditioning cycle”

in progress.

Wait for the end of the

“reconditioning cycle” (15

minutes).

The vacuum

cycle is stopped

within a few

seconds and

the button

ashes.

The cover gasket is dirty or

worn.

Clean or replace the gasket of

the cover and check that it is

closed properly.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Comentarios a estos manuales

Sin comentarios