Electrolux CF 376 Guía de uso y cuidado descargar pdf (Pagina 12)

Removing the Doors

Installing Freezer Drawer

1 With lower slides pulled out, hang drawer onto

slide brackets ensuring pins on each side are

fully inserted into slots on each side.

6 Tighten four (4) drawer screws.

7 Recheck gasket seal.

8 Install the toe grille by ﬁtting into place.

2 Reinstall four (4) drawer screws (two (2) per

side), tighten down, and close drawer (C).

Pull Drawer Out

From Both Sides

Grab Drawer

At Center

Then

Push Against

Freezer Drawer

A B

Fully Extend

Assembly

Drawer Slides

Slot

Cabinet

Drawer

3 Check gasket seal around top, bottom, and sides

of freezer drawer.

4 If gasket is not sealed, open drawer and slightly

loosen four (4) drawer screws (two (2) on each

side) to allow drawer to rotate.

5 Close drawer and recheck the seal on the gasket

(A).Openthedrawergrabbingbythesidesinthe

center (B). Be careful not to rotate the drawer.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Sin comentarios

Electrolux CF 376 Guía de uso y cuidado Pagina 12