Electrolux EEC5700AOX Manual de usuario Pagina 28

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 36
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 27
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
2
1
Install the shelf supports in the opposite
sequence.
12.4 Pyrolysis
CAUTION!
Remove all accessories and
removable shelf supports.
The pyrolytic cleaning
procedure cannot start:
• if you did not fully close
the oven door. In some
models, the display
shows "C3" when this
error occurs.
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them at
the same time as the
Pyrolysis function. It can
cause damage to the
appliance.
During the pyrolytic cleaning the door is
locked. The symbol and the bars of
the heat indicator come up, until the door
unlocks. The door unlocks when the
temperature inside the oven is under
safety conditions and the pyrolytic
cleaning finishes.
During the pyrolytic cleaning the lamp is
deactivated.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Activate the appliance.
4. Touch again and again until the
display shows "Pyro" and the number
of the cleaning programme.
5. Touch .
6. Touch
or to set the duration
of the cleaning procedure:
Option Description
1 1:00 h for a
low degree
of dirt
2 1:30 h for a
usual degree
of dirt
3 2:30 h for a
high degree
of dirt
You can use the End function to
delay the start of the cleaning
procedure.
7. Touch to activate the Pyrolysis
function.
12.5 Cleaning reminder
To remind you that the pyrolytic cleaning
is necessary, the cleaning reminder
symbol
flashes in the display after
each deactivation of the appliance for the
next 10 seconds.
The cleaning reminder
goes out:
• after the end of the
pyrolytic cleaning.
• when you deactivate it in
the basic settings. Refer
to "Using the settings
menu".
www.electrolux.com28
Vista de pagina 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Comentarios a estos manuales

Sin comentarios