
7.7 Door reversibility
A2
A1
To change the opening direction of the
door, do these steps:
• Remove the plug from the power sock-
et.
• Remove the ventilation grille. Remove
the filling and install it on the opposite
side of the grille.
• Lay down the appliance back side
down on a wooden support.
• Unscrew the upper hinge (A1) and the
cover washer (A2) and install this on the
opposite side.
• Unscrew the lower hinge. Change the
position of the pin and buffert. Screw
the lower hinge on the opposite side.
• Tighten the pin with the adjustment
spanner supplied.
• Raise the appliance and install the ven-
tilation grille.
• Remove the covers on the handles
carefully with a small screwdriver.
• Unscrew the handle.
• On the opposite side remove the hole
covers by driving a 3-4 mm drift or drill
into them.
• Install the handle.
• Install the covers on the handle.
• Install the hole covers provided within
the accessory bag.
• Put the cabinet in position.
WARNING!
Reposition, level the appliance,
wait for at least four hours and
then connect it to the power
socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabi-
net.
• The door opens and closes correctly.
WARNING!
If the ambient temperature is cold
(i.e. in Winter), the gasket may not
fit perfectly to the cabinet. In that
case, wait for the natural fitting of
the gasket.
14
www.electrolux.com
Comentarios a estos manuales