Electrolux RC1180 Manual de usuario Pagina 9

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 12
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 8
9
9.2 CONNECTING TO VEHICLE
BATTERY
Make sure no other energy source is connected (gas,
230V).
The 12V female socket is on the backwall of the
appliance, while the suitable male plug with a 2,5m
long wire is an accessory supplied with your new
appliance.
Make the connection to 12 volt vehicle battery by a
professional vehicle service the following way:
The free end of the cable must be connected to
positive and negative pole of the battery.
Attention: connection to the positive pole may
only be made through a 16A fuse!
One possible way of the connecting can be seen (on
figure 6.)
A - fuse holder with 16A fuse
B - wire ties
C - positive battery cable
If the 2,5m long cable proves to be short, up to 4m
length 2,5mm
2
;while up to 6m length 4,0mm
2
sectioned cable must be used.
Pay attention to the voltage values noted on the rating
label and on a label placed below the female socket!
The 12V operation is turned on by connecting the plug
and cut off by disconnecting the plug.
Push the fixing tab with a screw-driver as can be seen
(in figure 7). After that the plug can be disconnected.
9.3 Connecting to gas cylinder
Make sure no other energy source is connected
(230V, 12V).
The unit must not be connected to town or natural gas
pipelines. It is only suitable for use with
propane/butane gas (e.g. Calor Gas, Camping Gaz,
Caravangas, etc.).
The RC 1180 is equipped for a specific gas-pressure,
corresponding to the standard pressure of the country
in which it is sold. The rating-plate states the pressure
that is correct. It is important that a non-adjustable
pressure-regulator is used to reduce the pressure in
the gas cylinder to the operating pressure specified
on the rating-plate. No other pressure may be used.
Needle valve-operated gas control taps are NOT
suitable for use with this appliance and must not be
used as a substitute for a pressure regulator.
Figure 6.
Figure 7.
Vista de pagina 8
1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios