Electrolux RO400B Manual de usuario descargar pdf (Pagina 13)

If the RO 400 has not been used for a time,

it may take up to 60 seconds before the

optimum water purification level is reached,

as shown by lights on the spigot and

control panel.

Once the RO 400 has been installed and calibrated according to the "

Installation

" instructions, it

is ready for use.

The RO 400 has an electronic control system which makes it easy for you to use. Normally you

will only need to remember a few points:

• To use the spigot connected to the appliance only when you want to draw off water of good

quality, as indicated on the front panel.

• To replace Filters I and II once or twice a year, or when the indicators on the front panel show

they need replacing.

• To descale the water purifier at the intervals recommended.

• Clean the grid at the intake valve.

USING THE RO 400

To draw purified water

The RO 400 produces purified water when the spigot is

moved to either of the "On" positions shown in Fig. B.

When the spigot lever is moved to Position 1, the spigot

will stay on (hands-free) at maximum flow until the lever is

moved back manually to the "Off" position.

The lever has to be pressed and held when Position 2 is

used (also maximum flow).

The indicator lights on the spigot show the current water

quality:

• green light: acceptable water purification level

• red light: unacceptable water purification level

Only use the water purified when the purification level

II or III is indicated on the display panel or when a

green light shows on the spigot indicator.

The RO 400 has automatic features designed to

optimize the service life of the membrane:

• Just after you draw water each time, the appliance will

switch to flushing mode automatically, to clean the

membrane. The length of this flushing will vary (5 to 90

seconds) according to how long the spigot was open.

• If the spigot is left on for longer than 20 minutes, the

appliance will shut down automatically. To restart it,

follow the instructions in the "Trouble-shooting table".

• The appliance will switch automatically to flushing mode

for a brief period once every 12 hours (approximately),

provided the water and power supplies are connected.

This periodic flushing takes place no matter when the

appliance was last used.

When using the RO 400, it is sensible to fill a jug with

drinking water while it is operating. Try to avoid starting it

working just to fill a single glass at a time. This helps save

water, because each time the appliance purifies water, a

certain amount is lost (via the reject water outlet) before the

optimum purification level is reached, and the RO 400 also

switches to flushing mode after it is used.

1 On

2 On

Off

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comentarios a estos manuales

Sin comentarios

Electrolux RO400B Manual de usuario Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para No Electrolux RO400B