Electrolux ERW3313AOX Manual de usuario descargar pdf (Pagina 11)

Problem Possible cause Solution

The temperature in the

appliance is too high.

Contact a qualified electri‐

cian or contact the nearest

Authorized Service Centre.

A rectangular symbol is

shown instead of numbers

on the Temperature Dis‐

play.

Temperature sensor

problem.

Contact the nearest Author‐

ized Service Centre (the

cooling system will continue

to keep food products cold,

but temperature adjustment

will not be possible).

The lamp does not work. The lamp is in stand-by. Close and open the door.

The lamp is defective. Refer to "Replacing the

lamp".

The compressor operates

continually.

Temperature is set incor‐

rectly.

Refer to "Operation" chapter.

Many products were put

in at the same time.

Wait some hours and then

check the temperature

again.

The room temperature is

too high.

Refer to climate class chart

on the rating plate.

Products placed in the

appliance were too

warm.

Allow products to cool to

room temperature before

storing.

The door is not closed

correctly.

Refer to "Closing the door".

Water flows on the rear

plate of the refrigerator.

During the automatic de‐

frosting process, frost

melts on the rear plate.

This is correct.

Water flows inside the

wine cellar.

The water outlet is clog‐

ged.

Clean the water outlet.

Products prevent that

water flows into the water

collector.

Make sure that products do

not touch the rear plate.

DEMO appears on the dis‐

play.

The appliance is in dem‐

onstration mode.

Keep the Light button press‐

ed for approximately 10 sec‐

onds until a long sound is

heard and display shuts off

for a short time.

The temperature in the

wine cellar is too low/too

high.

The temperature regula‐

tor is not set correctly.

Set a higher/lower tempera‐

ture.

The door is not closed

correctly.

Refer to "Closing the door".

ENGLISH 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comentarios a estos manuales

Sin comentarios