Electrolux EWW12470 Manual de usuario descargar pdf (Pagina 38)

38 electrolux installation

6. Open the porthole, take out the inlet

hose from the drum and remove the

polystyrene block on the door seal.

7. Fill the smaller upper hole and the two

large ones with the corresponding

plastic plug caps supplied in the bag

containing the instruction booklet.

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around

the machine is not impeded by

carpets, rugs etc. Check that the

machine does not touch the wall or

other kitchen units. Level the washer-

dryer by raising or lowering the feet.

The feet may be tight to adjust as they

incorporate a self locking nut, but the

machine MUST be level and stable.

If necessary, check the setting with a

spirit level.

Any necessary adjustment can be

made with a spanner.

HEC0005

HEC0010

Accurate levelling prevents vibration,

noise and displacement of the machine

during operation.Never place

cardboard, wood or similar materials

under the machine to compensate for

any unevenness in the floor.

Water inlet

An inlet hose is supplied and can been

found inside the machine drum. Do not

use the hose from your previous

machine to connect to the water

supply.

1. Open the porthole and extract the

inlet hose.

2. Connect the hose with the angled

connection to the machine.

Do not place the inlet hose

downwards. Angle the hose to the

left or right depending on the

position of your water tap.

HEC0006QL

HEC007S

132964080.qxd 14/02/2008 10.50 Pagina 38

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Comentarios a estos manuales

Sin comentarios