Electrolux IK2680 Manual de usuario

user manualFridge-FreezerIK2680

TECHNICAL DATA Dimension of the recess Height 1580 mm Width 560 mm Depth 550 mmRising Time 20 hThe technical information are situated in

1. Tighten the lower pin.2. Install the lower door.3. Tighten the middle hinge.4. Install the spacer.5. Install the upper door.6. Tighten the upper pi

3. Adjust the appliance in the niche.Make sure that the distance betweenthe appliance and the cupboard front-edge is 44 mm.The lower hinge cover (in t

7. If the appliance must connect laterallyto the kitchen furniture door:a) Loosen the screws of the part (G)and move the part (G).b) Tighten the screw

11. Open the appliance door and the kitch-en furniture door at an angle of 90°.Insert the small square (Hb) into guide(Ha).Put together the appliance

product is disposed of correctly, you willhelp prevent potential negativeconsequences for the environment andhuman health, which could otherwise becau

212715121-00-28092010 www.electrolux.com/shop

Electrolux. Thinking of you.Share more of our thinking at www.electrolux.comCONTENTSSafety information 2Operation 4First use 4Daily use 4Helpfu

damage to the cord may cause a short-circuit, fire and/or electric shock.Warning! Any electrical component(power cord, plug, compressor) mustbe replac

• Make sure that the mains plug is accessi-ble after the installation of the appliance.•Connect to potable water supply only. 4)Service• Any electrica

er settings to obtain the maximum cold-ness.Important! In this condition, the refrigeratorcompartment temperature might dropbelow 0°C. If this occurs

ously, causing frost or ice on the evapo-rator. If this happens, set the Tempera-ture Regulator toward warmer settings toallow automatic defrosting an

• rinse and dry thoroughly.Important! Do not pull, move or damageany pipes and/or cables inside the cabinet.Never use detergents, abrasive powders,hig

Periods of non-operationWhen the appliance is not in use for longperiods, take the following precautions:•disconnect the appliance from elec-tricity s

Problem Possible cause SolutionThe temperature in theappliance is too high.The temperature regulator is notset correctly.Set a lower temperature. The