Electrolux ECM1957 Manual de usuario descargar pdf (Pagina 5)

INITIAL START UP

Stick the plug into the socket, then turn the temperature

controller away from the "off" zone, this way the green lamp

showing the energy supply will be on.

- If the temperature adjuster is in the "off" zone and the

plug of the device has been connected to the socket,

the device will not work, neither will the display, and the

control lamps will not be on.

- The device runs in SUPER FROST mode for 5 hours,

the yellow SUPER FROST indicator lamp will be on.

- If you want to stop the SUPER FROST mode, keep

pressing the SUPER FROST button for 2 seconds. At

this time, instead of the "SP" sign, the display will show

the inner temperature, the yellow lamp indicating

SUPER FROST will go out.

All models have a digital temperature display integrated in

the handle of the lid. In normal operation, it shows the

temperature of the frozen products in centigrade (°C).

There are however the following exceptions:

- During fast freezing FROSTMASTIC function SP is

shown.

- If there is a failure of the temperature display, a small

square can be seen in the bottom right or top right

corner. (Also see section "Something Not Working").

The temperature display indicates the temperature of

the frozen food and therefore changes relatively

slowly, if you put fresh goods in for example. If you leave the

lid open for a long time, the temperature warning may

respond, the temperature display may however remain

unchanged. In this case there is no malfunction. Press the

WARNING OFF button, to switch the warning buzzer off. The

red warning light goes out automatically after a short time.

After power-supply failure or when starting up the device

for the first time, the device switches to SUPER FROST

mode for 5 hours, if the temperature in the freezer is too

high. An "SP" sign will appear on the display. If you want

to switch it off before the 5 hours is over, keep pressing

the SUPER FROST button for 2 seconds.

TEMPERATURE WARNING

If the temperature in the freezer is too high, the warning

buzzer sounds and the red warning light flashes.

The warning buzzer and red warning light are triggered:

- if the storage temperature required has not yet been

reached when starting the freezer; if the storage

temperature is no longer maintained (malfunction);

- after inserting fresh foodstuffs in a greater quantity

than permitted by the freezing capacity (see section

on "Freezing";

- if the lid is left open too long.

You can switch off the warning buzzer with the

WARNING OFF button. The red warning light

continues to flash until it is sufficiently cold again

inside the freezer.

The warning buzzer and red warning light are not

triggered:

- if the power supply is interrupted;

- if the electronic thermostat is faulty.

Digital temperature display

1 2 3 4 5 6 7 8 9 10 ... 15 16

Comentarios a estos manuales

Sin comentarios

Electrolux ECM1957 Manual de usuario Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Congeladores Electrolux ECM1957