
10
Electrolux 818 21 42-01/1
Removing the transport supports
Remove the tape and the transport supports from
· the door sides
· the shelves
Remove the t ransport support on the glass shelf by
pushing the support forward along the edge of the
shelf until it stops. Take hold of t he rear edge of the
glass shelf and pull the shelf and transport support
forward until the shelf tilts and the transport support
can be removed. Some models are fitted with a
silencing pad under the cabinet. Do not remove this
pad.
Cleaning
Wash the inside of the appliance using lukewarm
water and bicarbonate of soda (5 ml to 0,5 litre of
water).
Do not use soap or detergent as the smell may
linger. Dry thoroughly.
Installing the appliance
When two appliances are placed beside each other,
the distances enclosed in the plastic wrapping should
be glued between the appliances. As shown in t he
illustration.
To obtain the best performance from the appliance,
ensure :
· the appliance is placed in a dry, cool place and
is not exposed to direct sunlight.
· the applianceis not placed close to a source of
heat, e.g. a cooker or dishwasher.
· the appliance is level. The appliance should not
lean
against any wall. If necessary adjust the
feet using the adjustment spanner supplied.
· there is good air circulation around the appliance
and that the air channels below and behind
the appliance are not blocked. The ventilation
space above the appliance must be at l east 4 cm.
The ventilation space can either be
a) directly above the appliance, or
b) behind and above the top cupboard. In this case,
the space behind the cupboard must be at least
50 mm deep.
The appliance must be placed at a location whose
ambient temperature corresponds to the climate
classification*, for which the appliance is designed.
* See on the rating plate on the inside of the
appliance.
The following table shows which ambient
temperature is correct for each climate classification.
50mm
a)
b)
Comentarios a estos manuales