Electrolux EHE6002X Manual de usuario descargar pdf (Pagina 16)

16 electrolux

Electrical Connections

Any electrical work required to install this hob should be carried out

by a QUALIFIED ELECTRICIAN or COMPETENT PERSON, in

accordance with the current regulations.

THIS HOB MUST BE EARTHED.

The manufacturer declines any liability should these safety measures not be

observed.

This hob is designed to be connected to a 230 V~ 50 Hz electrical supply.

Before switching on, make sure the electricity supply voltage is the same as

that indicated on the hob rating plate. The rating plate is located on the bottom of

the hob. A copy is attached on the back cover of this book.

Before carrying out the connection, make sure:

1) the limiter valve and the electrical system can take the appliance load (see

the rating plate);

2) the supply system is equipped with an efficient earth connection in

compliance with the current standards and regulations;

3) the outlet or omnipolar switch used for connection are easily accessible with

the appliance installed.

The appliance is not equipped with a power cable.

A cable of section adequate for the load must be installed on the equipment.

The type of cable must have at least T90 temperature characteristics.

It is advisable to use the following types of cables or others with similar

characteristics: H05 V2V2-F. The cable has three wires.

1) Remove the mains terminal cover plate from the underside of the hob, to

expose the mains terminal block (Fig.3).

2) Loosen the two cable clamp screws and lift the top section of the clamp

enough to allow the cable to be passed through.

3) Connect the red (live) wire to the terminal which is marked with the

number

1 1

1 (Fig.3).

4) Connect the black (neutral) wire to the

terminal which is marked with the number

4 4

4 (Fig.3).

5) After fitting a green or yellow/green sleeve

over the bare copper wire (earth wire),

connect the exposed end to the terminal

which is marked with the earth symbol

or with the number

(Fig.3).

NOTE: the earth wire is yellow/green and must

be approx. 2 cm longer than the phase and neutral

wires (Fig. 2).

)

Fig. 2

Neutral

Earth (yellow/green)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

Electrolux EHE6002X Manual de usuario Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Electrolux EHE6002X