Electrolux EHT6432K Manual de usuario descargar pdf (Pagina 17)

electrolux 17

Installation

IMPORTANT

This hob must be installed by a competent person to the relevant Gas

Standards.

Any gas installation must be carried out by a registered competent person.

The manufacturer will not accept liability, should the above instructions or any of the

other safety instructions incorporated in this book be ignored.

On the end of the shaft, which includes the GJ 1/2" threaded elbow, adjustment is

fixed so that the washer is fitted between the components as shown in the diagram.

Screw the parts together without using excessive force.

A) End of shaft with nut

B) Washer

C) Elbow

FO 0264

It is important to install the elbow correctly, with the shoulder on the end of the

thread, fitted to the hob connecting pipe.

Failure to ensure the correct assembly will cause leakage of gas.

Gas Connection

Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel

or copper.

The connection should be suitable for connecting to RC 1/2 (1/2 BSP male

thread).

When the final connection has been made, it is essential that a thorough leak test is

carried out on the hob and installation.

Ensure that the main connection pipe does not exert any strain on the hob.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Sin comentarios

Electrolux EHT6432K Manual de usuario Pagina 17