Electrolux EHT6432K Manual de usuario descargar pdf (Pagina 24)

24 electrolux

A. EARTH CONTINUITY CHECK

Appliance must be electrically disconnected - meter set on Ω (Ohms) x 1 scale and adjust

zero if necessary.

— Test leads from any appliance earth point to earth pin on plug. Resistance should be less

than 0.1 Ω (Ohm), check all earth wires for continuity and all contacts are clean and tight.

B. INSULATION CHECK

Appliance electrically disconnected, all switches ON.

a) meter set on Ω (Ohms) x 1 scale.

Test leads from L to N in appliance terminal block. If meter reads «0» then there is a short

circuit.

b) meter set on Ω (Ohm) x 100 scale.

Repeat test with leads from L to E. If meter reads less than ∞ (infinity) there is a fault.

NOTE - Should it be found that the fuse has failed but no fault is indicated - a detailed continuity check

(i.e. by disconnecting and checking each component) is required to trace the faulty component.

It is possible that a fault could occur as a result of local burning/arcing but no fault could be found under

test. However a detailed visual inspection should reveal evidence of burning around the fault.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Sin comentarios

Electrolux EHT6432K Manual de usuario Pagina 24