Electrolux EKM6035 Manual de usuario descargar pdf (Pagina 35)

electrolux 35

Electrical connection

The unit is preset to work with a

voltage of single phase 230 V.

Before making the connection make

sure that:

- the energy power available in the

user's house is sufficient for the nor-

mal supply of this appliance (see

rating plate).

- the unit is correctly connected to

earth through a suitable plug and

according to the installation country

Laws.

- the socket or the omnipolar switch

used for the connection must be

easilv reached with the installed

appliance.

The appliance is supplied with

electric cable, therefore you will have to

fit it with a standard plug, suitable for the

total electric load shown on the rating

plate. The plug is to be inserted into a

suitable wall socket.

If you wish to directly connect to the

mains, you have to interpose an

omnipolar switch with a minimum

opening between contacts of 3 mm,

between the unit and the mains,

complying with the existing regulations.

The brown live wire (originating from the

clamp of the appliance junction box)

must always be connected to the phase

of the mains supply. In any case, the

supply cord must be positioned in such

a way as it doesn't reach in any point a

temperature higher by 50°C than the

room temperature.

Replacement of the electric cable

Should the supply cord need to be

replaced, use only the following cable

types: H07 RN-F, H05 RN-F, H05 RR-

F, H05 VV-F, H05 V2V2-F (T90), H05

BB-F. It is necessary that the yellow/

green earth wire is about 2 cm longer

than the live and neutral ones (Fig. 5).

After the connection, test the heating

elements for about 3 minutes to ensure

that they are working correctly.

The manufacturer refuses any

responsability in cases where

normal safety measures are not

observed.

Ground yellow-green

Neutral

wire

Phase

Fig. 5

1 2 ... 30 31 32 33 34 35 36 37

Comentarios a estos manuales

Sin comentarios