
side of the appliance into the circular
hole on the bracket. See the
illustration. Screw it into the solid
material or use applicable
reinforcement (wall).
3. You can find the hole on the left side
at the back of the appliance. See the
illustration. Put the appliance in the
middle of the space between the
cupboards (1). If the space between
the bench cupboards is larger than
the width of the appliance, you must
adjust the side measurement to
centre the appliance.
13.5 Electrical installation
WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
This appliance is supplied without a main
plug or a main cable.
Applicable types of cables for
different phases:
Phase Min. size cable
1 3x10.0 mm²
3 with neutral 5x1.5 mm²
WARNING!
The power cable must not
touch the part of the
appliance shaded in the
illustration.
14. ENERGY EFFICIENCY
14.1 Hob - Energy saving
You can save energy during everyday
cooking if you follow below hints.
• When you heat up water, use only the
amount you need.
• If it is possible, always put the lids on
the cookware.
• Before you activate the cooking zone
put the cookware on it.
• The cookware bottom should have the
same diameter as the cooking zone.
• Put the smaller cookware on the
smaller cooking zones.
• Put the cookware directly in the centre
of the cooking zone.
• Use the residual heat to keep the food
warm or to melt it.
www.electrolux.com30
Comentarios a estos manuales