Electrolux EHD60020P 34W Manual de usuario descargar pdf (Pagina 17)

electrolux 17

Installation Instructions

1 Safety instructions

Warning! This must be read!

The laws, ordinances, directives and stand-

ards in force in the country of use are to be

followed (safety regulations, proper recycling

in accordance with the regulations, etc.)

Installation may only be carried out by a qual-

ified electrician.

The minimum distances to other appliances

and units are to be observed.

Anti-shock protection must be provided by

the installation, for example drawers may

only be installed with a protective floor direct-

ly underneath the appliance.

The cut surfaces of the worktop are to be

protected against moisture using a suitable

sealant.

The sealant seals the appliance to the work

top with no gap.

When building in, protect the underside of

the appliance from steam and moisture, e.g.

from a dishwasher or oven.

Avoid installing the appliance next to doors

and under windows. Otherwise hot cook-

ware may be knocked off the rings when

doors and windows are opened.

z Risk of injury from electrical

current.

• The electrical mains terminal is live.

• Make electrical mains terminal free of

voltage.

• Follow connection schematic.

• Observe electrical safety rules.

• Ensure anti-shock protection by install-

ing correctly.

• The appliance must be connected to the

electrical supply by a qualified electri-

cian.

z Risk of injury from electrical

current.

• Loose and inappropriate plug and sock-

et connections can make the terminal

overheat.

• Have the clamping connections correct-

ly installed by a qualified electrician.

• Use strain relief clamp on cable.

• In the event of single-phase or two-

phase connection, the appropriate

mains cable of type H05BB-F Tmax

90°C (or higher) or an equivalent type

must be used.

• If this appliance’s mains cable is dam-

aged, it must be replaced by a special

cable (type H05BB-F Tmax 90°C; or

higher) or an equivalent type. Please

contact your local Service Force Center

for further advice.

A device must be provided in the electrical

installation which allows the appliance to be

disconnected from the mains at all poles with

a contact opening width of at least 3 mm

Suitable isolation devices include line pro-

tecting cut-outs, fuses (screw type fuses are

to be removed from the holder), earth leak-

age trips and contactors.

Sticking on the seal

• Clean the worktop in the area of the cut-

out section.

• Stick the one-sided self-adhesive seal-

ing tape supplied all the way round the

lower edge of the cooking surface along

the outer edge of the glass ceramic pan-

el. Do not stretch it. The cut ends should

lie in the middle of one side. When you

have cut it to length (add a few mm),

press the two ends flush up against one

another.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios