Electrolux EHG90932X Manual de usuario descargar pdf (Pagina 6)

must fit an applicable pressure adjuster on

the gas supply pipe.

Adjustment of minimum level

To adjust the minimum level of the burner:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the control knob.

4. With a thin screwdriver, adjust the by-

pass screw position. If you change from

natural gas 20 mbar to liquid gas, fully

tighten the adjustment screw in. If you

change from liquid gas to natural gas 20

mbar, undo the by-pass screw approxi-

mately 1/4 of a turn for screw 2, 1/3 of a

turn for screw 1.

1

2

1 Minimum adjustment screw for dual

burner both crowns

2 Minimum adjustment screw for dual

burner internal crown

5. Make sure the flame does not go out

when you quickly turn the knob from the

maximum position to the minimum posi-

tion.

Electrical connection

• Any electrical work required to install this

hob should be carried out by a qualified

electrician or competent person, in ac-

cordance with the current regulations.

• THIS HOB MUST BE EARTHED.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is an access to the

mains plug after installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains

plug.

• The appliance must not be connected

with an extension cable, an adapter or a

multiple connection (risk of fire). Check

that the ground connection is in conform-

ity with the standard and regulations

force.

• The power cable must be placed in such

a way that it does not touch any hot part.

• Connect the appliance to the mains with

a device that lets to disconnect the appli-

ance from the mains at all poles with a

contact opening width of minimum 3

mm, eg. automatic line protecting cut-

out, earth leakage trips or fuse.

• None of a parts of the connection cable

can not get a temperature 90°C.

Electrical Requirements

Any permanent electrical installation must

comply with the latest I.E.E. Regulations

and local Electricity Board regulations. For

your own safety this should be undertaken

by a qualified electrician, e.g. your local

Electricity Board, or a contractor who is on

the roll of the National Inspection Council

for Electrical Installation Contracting (NICE-

IC).

The manufacturer declines any liability

should these safety measures not be

observed.

This hob is designed to be connected to a

230 V 50 Hz AC electrical supply.

Before switching on, make sure the elec-

tricity supply voltage is the same as that in-

dicated on the hob rating plate. The rating

plate is located on the bottom of the hob.

The hob is supplied with a 3 core flexible

supply cord incorporating a 3 amp plug fit-

ted. In the event of having to change the

fuse, a 3 amp ASTA approved (BS 1362)

fuse must be used.

6 electrolux

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comentarios a estos manuales

Sin comentarios