Electrolux EHP333X Manual de usuario descargar pdf (Pagina 12)

12

The decorative pattern on the ceramic

surface can become scratched and

marred with use, depending upon

maintenance, but does not adversely

affect performance.

Such blemishes are not covered by the

warranty and do not affect the

operation of the hob.

Spills and melts must be removed

immediately, while the surface is still

warm, using the scraper supplied with

the unit. Especially damaging are melted

plastic, aluminum, or any foodstuff

containing sugar, including natural sugar,

as these can create permanent

“pockmarks” and craters on the ceramic

surface. After scraping polish thoroughly

with the cleaning agent supplied with the

unit.

Utensils which have been in contact with

the above-mentioned melted materials

must be cleaned throughly before used

again on the ceramic-top hob unit.

Defects in the ceramic surface which can

be related to the above are not covered

by the warranty.

Warning:

Aluminum foil and plastic utensils are

not to be placed on hot surfaces.

The surface may not be used for storage.

Do not stare at the heating units when

in operation.

13

Minimum distance

to wall:

150 mm

Minimum distance

to wall (non-

flammable material):

150 mm

Reinforcement

beams

Mounting

Caution: In order to avoid a hazard this

appliance must be installed according to

these instructions for installation

The appliance unit can be mounted in

any type of kitchen with a work top

whose thickness is between 28 mm and

40 mm.

Clearance

The distance between the top side of the

work top and the carpentry underneath

must be at least 47 mm.

Fixing

Screw the fixing brackets out to such an

extent that they can be turned in under

the work top. Tighten the brackets on to

the work top with an ordinary

screwdriver.

Cut-out measurements

One rectangular hole is sawn out for the

appliance combination chosen.

The depth of the cut-out for any unit is:

490 mm

Length of hole = sum of all units`

externally measured length, less 20 mm.

Mounting of Reinforcement

Beams

A reinforcement Beam, with supporting

flanges at each end, is included with

each two-burner unit. For unit

combinations, a reinforcement beam

must be used between each unit.

Min. 47 mm

1 2 ... 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios