Electrolux EKM601301X Manual de usuario descargar pdf (Pagina 22)

3. Using a socket spanner 7 unscrew and

remove the nozzles replacing them with

the ones required for the kind of gas in

use (see table " Burner characteristics " ).

4. Reassemble the parts following the same

procedure backwards.

5. Replace the rating label (placed near the

gas supply pipe) with the relevant one for

the new type of gas supply. You can find

this label in the package of the injectors

supplied with the appliance.

These burners do not need any primary air

regulation.

Adjustment of minimum level

To adjust the minimum level of the burners,

proceed as follows:

1. light the burner;

2. turn the knob on the position of minimum

flame;

3. remove the knob;

4. with a thin screwdriver, adjust the bypass

screw;

If changing from natural gas 20 mbar/13

mbar to liquid gas, completely tighten

the adjustment screw in, until a small

regular flame is obtained.

If changing from liquid gas to natural gas

20 mbar, undo the by-pass screw about

1/4 of a turn, until a small regular flame

is obtained.

If changing from natural gas 20 mbar to

natural gas 13 mbar undo the by-pass

screw about 1/4 of a turn, until a small

regular flame is obtained.

If changing from liquid gas to natural gas

13 mbar, undo the by-pass screw about

3/4 of a turn, until a small regular flame

is obtained.

Reassemble the parts following the same

procedure backwards.

Finally, check the flame does not go out

when quickly turning the knob from the max-

imum position to the minimum position.

Electrical connection

The unit is preset to work with a voltage of

single phase 230 V.

Before making the connection make sure

that:

• the energy power available in the user's

house is sufficient for the normal supply of

this appliance (see rating plate)

• the unit is correctly connected to earth

through a suitable plug and according to

the installation country Laws

• the socket or the omnipolar switch used

for the connection must be easilv reached

with the installed appliance

The appliance is supplied with electric cable,

therefore you will have to fit it with a standard

plug, suitable for the total electric load shown

on the rating plate. The plug is to be inserted

into a suitable wall socket.

If you wish to directly connect to the mains,

you have to interpose an omnipolar switch

with a minimum opening between contacts

of 3 mm, between the unit and the mains,

complying with the existing regulations.

The brown live wire (originating from the

clamp of the appliance junction box) must al-

ways be connected to the phase of the mains

supply. In any case, the supply cord must be

positioned in such a way as it does not reach

in any point a temperature higher by 50

°

C

than the room temperature.

Replacement of the electric cable

Warning! The replacement of electric

cable must be carried out exclusively by

the service force centre or by personnel

with similar competencies, in

accordance with the current regulations.

22 electrolux

1 2 ... 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios