
min. 550
589
594
114
16
573
580
min. 560
558
21548
65 cm
2
x2
130 cm
2
110
50
9
6
min. 550
110
600
min. 560
558
589
594
114
16
573
21548
65 cm
2
x2
130 cm
2
min. 4 mm
3
6
• There must be a clearance of
minimum 4 mm between the top
surface of the appliance and the inner
top of the cabinet.
• When you install the appliance "built-
under" (below a hob), install the hob
before the oven unit.
• The materials must be resistant to a
temperature increase of minimum 60
°C above the ambient temperature.
• There must be a continuous air supply
around the oven in order to not have
the oven become too hot.
• For correct operation, the oven
cabinet must have a minimum
opening of 130 cm² in the front or on
the sides (a minimum of 65 cm² for
each side). The manufacturer
recommends a 130 cm² opening in
the front for a brick cabinet and a 65
cm² opening for each side for a
wooden cabinet.
• When you install a hob above the
oven, make different electrical
connections for the hob and for the
oven.
Only make connections with correct
cables for the power supplied.
Make sure that after the
installation there is easy
access to the appliance if
repairs or maintenance are
necessary.
12.5 Securing the appliance to
the cabinet
12.6 Electrical installation
The manufacturer is not
responsible if you do not
follow the safety precautions
from the Safety chapters.
This appliance is supplied only with a
main cable.
12.7 Cable
Cable types applicable for installation or
replacement:
H07 RN-F, H05 RN-F, H05 RRF, H05
VV-F, H05 V2V2-F (T90), H05 BB-F
For the section of the cable refer to the
total power on the rating plate. You can
also refer to the table:
Total power (W) Section of the ca‐
ble (mm²)
maximum 1380 3 x 0.75
www.electrolux.com22
Comentarios a estos manuales