Electrolux TY38TSICN Manual de usuario descargar pdf (Pagina 13)

• Replace the damaged mains cable with a

special cable (type H05VV-F or higher).

Speak to your local Service Centre.

ELECTRICAL CONNECTION

• Install the appliance with a socket supply

line. If there is no socket supply line, the

fixed home electrical system must include

an isolating device with at least a 3 mm-

contact separation to enable a simultane-

ous and all-pole cut off from the mains

(according to NIN SEV 1000).

• You can use the fixing clamps supplied

with the appliance to install it in a work-

top with a minimum thickness of 42 mm.

With thinner worktops you must use a

spacer (not supplied with the appliance).

TO ATTACH THE SEAL.

• If installing proud of the work surface, use

the sealing tape with dimensions 12x2

mm.

• Clean the worktop in the area of the cut

out section.

• Cut the one-sided self-adhesive sealing

tape supplied into four parts according to

the edge length of the cut-out and stick

to the worktop along the edge of the cut-

out. In doing so, the sealing tape should

protrude by approx. 3 mm over the edge

of the appliance on all sides.

• Do not stretch the sealing tapes when

sticking. Do not stick the ends on top of

each other, these should be pushed

against each other.

• After fitting the Teppan Yaki (using the

provided fitting material), the overlaying

sealing tape must be cut away on all

sides using a sharp knife. Take care not

to damage the worktop.

TO ATTACH THE SEAL TO THE

RABBET

• Clean the rabbet in the work surface.

• Bond the seal stripe supplied on the up-

per surface of the rabbet along the edges

of the cut out section.

• Cut the seal stripe into four pieces in rela-

tion to the length of the edges of the rab-

bet.

• For the four corners of the rabbet the

ends of the seal stripes must be cut into

mitres. Do not bond the ends over one

another.

• Bond the seal stripe flush into the corner

of the rabbet. Make sure that no silicon

compound can get below the appliance

when grouting.

ASSEMBLY

min.

50mm

min.

500mm

min.

2mm

electrolux 13

1 2 ... 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios