Electrolux GHGL4-45WE Manual de usuario descargar pdf (Pagina 18)

Discolouration of the catalytic surface

has no effect on catalytic properties.

SHELF SUPPORT RAILS

Removing the shelf support rails

1. Pull the front of the shelf support rail

away from the side wall.

2. Pull the rear shelf support rail away

from the side wall and remove it.

Installing the shelf support rails

Install the shelf support rails in opposite se-

quence.

The rounded ends of the shelf support

rails must point to the front!

REMOVING THE HEATING ELEMENT

You can remove the heating element to

clean the oven cavity. In this case proceed

as follows for possible cleaning actions:

Warning! Ensure that the oven has

cooled down sufficiently so that you

can touch heating elements safely!

There is a risk of burns!

1. Hold the heat element with two hands

at the front.

2. Pull the heating element out of the plug

connection to the front.

3. Reassembly in reverse order. Make

sure the heating element has a

good fit in the connecting socket

when inserting.

OVEN DOOR

To clean the oven door remove it.

Caution! Be careful when you remove

the door from the appliance. The door

is heavy!

Removing the oven door

1. Open the oven door as far as it goes.

2. Lift up clamping levers (A) on the two

door hinges fully.

A

A

3. Close the oven door until the first posi-

tion (angle approximately 45°).

45°

4. Hold of the oven door with one hand

on each side and pull it away from the

oven at an upwards angle.

Put the oven door with the outer side

down on a soft and level surface to

prevent scratches.

18 electrolux

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios